Volume 2 Chapter 4 Display Menus LABEL NONE and LABEL NONH

Back to Table of Contents

MEASURE ANGLE

Function

This display command is located in the 3D display for each hit.

It allows you to display the angle formed by 2 or 3 geometrical objects.

The geometrical objects can be atoms, centroids, dummy points, vectors or planes.

Ex.

When a calculation has been completed the red crosses at the selected atoms are still displayed. Selection of the REFRESH button will cause the red crosses and the display of the calculated value to vanish.

If the first two selected geometrical objects are atoms, centroids or dummy points then you will be prompted for the third atom, as in the above example.

On the other hand, only two prompts will be displayed for vectors and planes.

Thus you can display the angle between:

Related Commands

MEASURE DIST, MEASURE TORS

Back to Table of Contents

Volume 2 Chapter 4 Display Menus MEASURE DIST.